Razor Automobile Razor Automobile User Manual

0

Out of 0 Ratings

Owner's of the Razor Automobile Razor Automobile gave it a score of 0 out of 5. Here's how the scores stacked up:

  • Reliability

    0 out of 5

  • Durability

    0 out of 5

  • Maintenance

    0 out of 5

  • Performance

    0 out of 5

  • Ease of Use

    0 out of 5
of 13
 
Turn power switch off before conducting any maintenance procedures.
Before you begin, carefully turn unit upside down for easier access.
1 Using a 17mm open wrench
loosen locknut and remove rear
wheel located closest to the chain.
4 Remove c-clips on the axle
between the two bearings.
5 Lightly tap the end of the axle
with a rubber mallet. DO NOT USE
A HAMMER as this will damage the
thread. The brake drum and pulley
must be slid along the axle as your
tapping progresses.
2 Use a 3mm wrench to loosen
the brake.
6 When the axle end is clear of the
bearing hanger, remove the axle.
3 Use a 3mm wrench to loosen the
sprocket.
ASSEMBLY AND SET-UP
q Removing Rear Axle
6
q Replacing the Chain
Master Link
Note: Chain should be periodically
checked for grime build-up. If
necessary remove any dirt and/or
debris in and around the chain and
re-lubricate with WD-40.
secure clip
link plate
connector link
Master Link:
1 Locate the master link on the
replacement chain and with a
flat head screwdriver carefully
disengage the clip from the chain
to remove the link plate and
connector link.
2 Wrap the chain around both
sprockets and tension idler. Insert
the connector link all the way
through the chain and fit the link
plate over the connector link.
3 Using a flat head screwdriver,
carefully re-attach the clip on to the
link plate. The clip must point in the
drive direction of chain rotation.
clip
Drive Direction

   Find Your Products By Category