Razor Automobile ELECTRIC-POWERED GO KART User Manual

0

Out of 0 Ratings

Owner's of the Razor Automobile ELECTRIC-POWERED GO KART gave it a score of 0 out of 5. Here's how the scores stacked up:

  • Reliability

    0 out of 5

  • Durability

    0 out of 5

  • Maintenance

    0 out of 5

  • Performance

    0 out of 5

  • Ease of Use

    0 out of 5
of 20
 
4B-3.) To replace a rear wheel, make sure the keys are
properly seated in the axle and aligned with the key
ways in the wheel (Figure 11). Tighten the self-locking
nut securely.
NOTE: The razor logo on the tread must face out.
❏ 4C. REPLACING THE BELT. Occasionally the belt needs to be
replaced when worn out.
Tools required for rear wheel and axle removal: (1) 17 mm open end or
socket wrenches, (1) 5 mm Allen key, (1) 2 mm Allen key, (1) rubber
mallet.
NOTE: The exact procedure for belt replacement may vary depending on
how your Ground Force is configured. The following procedure is based on the
design at time of publication of this Owner’s Manual. If your Ground Force does
not look exactly like this, please check the Razor website (www. razor.com) for
updates.
4C-1.) Remove the seat and motor cover. Loosen the belt
adjustment jackscrew as described in 4A-1.
4C-2.) Loosen and remove the axle nut on the right side rear
wheel (Figure 12a).
4
C-3.) Loosen and remove the axle guard (Figure 12b). Re
move the spacer tube and any shims or rings that the
factory may have used to fine-tune the fit.
Figure 11

   Find Your Products By Category