RCA TV Mount MAF15BKR User Manual

0

Out of 0 Ratings

Owner's of the RCA TV Mount MAF15BKR gave it a score of 0 out of 5. Here's how the scores stacked up:

  • Reliability

    0 out of 5

  • Durability

    0 out of 5

  • Maintenance

    0 out of 5

  • Performance

    0 out of 5

  • Ease of Use

    0 out of 5
of 4
 
2
Hardware Kit
(A) M4 x 12 Screw (x4)
(B) M4 x 20 Screw (x4)
(C) M6 x 12 Screw (x4)
(D) M6 x 20 Screw (x4)
(E) 10mm Spacer (x4)
(F) M8 x 63 Lag Bolt (x3)
(G) Concrete Anchor (10mm, x3)
(H) Washer (9.5mm, x3)
(I) M6 Washer (x4)
(J) 3/16” Drill Bit
Mounting the wall plate
Drywall Installation
Important! For safety reasons, this mount must be secured to at least two wood studs no less than 16” apart.
The studs must be capable of supporting the combined weight of the mount and display.
5. Place the wall plate back against the wall and
attach it using the lag bolts (F) and lag bolt washers
(H) (see Fig. 1). Do not over-tighten these bolts
and do not release the wall plate until all bolts
are in place. Ensure that the wall plate remains
level after all bolts are secured.
1. Use a high quality stud fi nder to locate two adjacent
studs where you wish to install your mount. Mark
both edges of each stud to help identify the exact
center.
NOTE: You must use the center of each stud
to avoid cracking or splitting the wood during
installation.
2. Place the wall plate against the wall and level it
using the integrated bubble level.
3. While another person holds the wall plate in
position, mark four locations (two per stud) for
securing the mount to the wall.
4. Set the wall plate aside and drill a 3/16” pilot hole at
each marked location.
Fig.1
Concrete/Brick Installation
IMPORTANT! For safety reasons, the concrete wall must be capable of supporting the combined weight of
the mount and the display. The manufacturer takes no responsibility for failure caused by walls of insuffi cient
strength.
1. Place the wall plate against the wall in the desired
location and level it using the integrated bubble
level.
2. While another person holds the wall plate in place,
mark six evenly spaced locations on the wall for
securing the mount.
3. Set the wall plate aside and drill a 10 mm (3/8”) hole
at each marked location. Remove any excess dust
from the holes.
4. Insert a Concrete Anchor (G) into each hole so
that it is fl ush with the concrete surface. A hammer
can be used to lightly tap the anchors into place if
necessary.
5. Place the wall plate back against the wall and
attach it using the lag bolts (F) and lag bolt washers
(H). Do not over-tighten these bolts and do not
release the wall plate until all bolts are in place.
Ensure that the wall plate remains level after all bolts
are secured.

   Find Your Products By Category