Snow Joe Snow Blower Pro Series 21-Inch Cordless Snow Blower User Manual

0

Out of 0 Ratings

Owner's of the Snow Joe Snow Blower Pro Series 21-Inch Cordless Snow Blower gave it a score of 0 out of 5. Here's how the scores stacked up:

  • Reliability

    0 out of 5

  • Durability

    0 out of 5

  • Maintenance

    0 out of 5

  • Performance

    0 out of 5

  • Ease of Use

    0 out of 5
of 20
 
13
Proper Care for Battery + Charger
mWARNING! To reduce the risk of injury, always unplug
the charger and remove the battery pack from the charger
before performing any maintenance task. Never disassemble
the battery pack or charger. Contact your Snow Joe
®
+
Sun Joe
®
dealer or the Snow Joe
®
+ Sun Joe
®
customer
service center for ALL repairs.
1. To reduce the risk of injury and damage, never immerse
your battery pack or charger in liquid or allow any liquid to
ow inside these components.
2. Clean out dust and debris from charger vents and
electrical contacts by blowing with compressed air.
3. Use only mild soap on a damp cloth to clean the battery
pack and charger, and keep away from all electrical
contacts. Certain cleaning agents and solvents are
harmful to plastics and other insulated parts. Some of
these include gasoline, turpentine, lacquer thinner, paint
thinner, chlorinated cleaning solvents, ammonia, and
household detergents containing ammonia. Never use
ammable or combustible solvents around battery packs,
battery chargers, or tools.
4. The EcoSharp
®
iCHRG40 lithium-ion battery charger has
no serviceable parts.
Replacing the Rubber Plates
mWARNING! Make sure to turn o the switch and
remove the battery before performing any maintenance task
on your cordless snow blower.
NOTE: When replacing worn rubber plates, pay close attention
to the order in which you remove the plates. Insert the new
plates in the reverse order.
1. Detach the worn rubber plate assembly by removing the 8
sets of nuts and bolts used to secure it (Figs. 20 & 21).
2. Install the new rubber plate assembly by tightening the 8
sets of nuts and bolts on both sides (Fig. 20).
Replacing the Scraper Bar
1. The scraper bar is located at the base of the snow blower
beneath the rotor housing (Fig. 22).
2. Detach the worn scraper bar from the snow blower by
removing the 3 screws that hold it in place (Fig. 23).
3. Install the new scraper bar and fasten it securely to the
snow blower with the 3 screws (Fig. 22).
Fig. 20
Fig. 21
Fig. 22
Scraper
bar
3 Screws
Fig. 23

   Find Your Products By Category