Snow Joe Snow Blower 18-INCH 13-AMP ELECTRIC SNOW THROWER User Manual

0

Out of 0 Ratings

Owner's of the Snow Joe Snow Blower 18-INCH 13-AMP ELECTRIC SNOW THROWER gave it a score of 0 out of 5. Here's how the scores stacked up:

  • Reliability

    0 out of 5

  • Durability

    0 out of 5

  • Maintenance

    0 out of 5

  • Performance

    0 out of 5

  • Ease of Use

    0 out of 5
of 20
 
14
3. Remove the screws and the bushings from the drive wheel
(Fig. 34).
4. Remove the auger axle set (Fig. 35).
5. Remove the old auger from the housing (Fig. 36).
6. Install the replacement auger by following the above steps
in reverse order.
Replacing the Scraper Bar
1. The scraper bar is located at the base of the snow thrower
beneath the rotor housing (Fig. 37).
2. Remove the screws that secure the scraper to the snow
thrower (Fig. 38).
3. Install the new scraper bar and fasten it securely to the
snow thrower with the screws.
Replacing the Belt
NOTE: Under normal operating conditions, it should not be
necessary to replace the auger belt. However, should the auger
jam or malfunction, the belt could be damaged. To replace the
belt, follow the instructions.
NOTE: Determine the left and right hand side of the snow
thrower by standing behind the unit in the normal operating
position.
Fig. 34
Screws
Bushing
Fig. 35
Auger axle
set
Fig. 36
Fig. 37
Scraper
bar
Fig. 38
The screws that secure the scraper bar

   Find Your Products By Category