Pioneer Car Stereo System Pioneer Car Stereo System User Manual

0

Out of 0 Ratings

Owner's of the Pioneer Car Stereo System Pioneer Car Stereo System gave it a score of 0 out of 5. Here's how the scores stacked up:

  • Reliability

    0 out of 5

  • Durability

    0 out of 5

  • Maintenance

    0 out of 5

  • Performance

    0 out of 5

  • Ease of Use

    0 out of 5
of 52
 
Adjusting subwoofer settings
The cut-off frequency and output level can be
adjusted when the subwoofer output is on.
1 Use M.C. to select SW 2.
Refer to Introduction of audio adjustments on
page 20.
# When the subwoofer output is on, you can se-
lect SW 2.
2 Turn M.C. to select cut-off frequency.
50—63—80—100—125 (Hz)
Only frequencies lower than those in the se-
lected range are outputted from the subwoo-
fer.
3 Turn LEVER to adjust the output level
of the subwoofer.
+6 to -24 is displayed as the level is increased
or decreased.
Adjusting low pass filter attenuation
slope
When the subwoofer output is on, you can ad-
just the continuity of sound between speaker
units.
1 Use M.C. to select SW 3.
Refer to Introduction of audio adjustments on
page 20.
# When the subwoofer output is on, you can se-
lect SW 3.
2 Press M.C. to select the phase of sub-
woofer output.
NOR (normal)—REV (reverse)
3 Turn LEVER to select slope.
–18— –12— –6 (dB/oct.)
Note
When slope of subwoofer and high pass filter are
-12dB, and same cut-off frequency, the phase is
reversed 180 degrees at the cut-off frequency. In
this case, reversing the phase assures improved
sound continuity.
Using the high pass filter
When you do not want low sounds from the
subwoofer output frequency range to play
from the front or rear speakers, turn on the
HPF (high pass filter). Only frequencies higher
than those in the selected range are output
from the front or rear speakers.
! This function is only available in standard
mode
.
Muting the speaker units (filters)
You can mute front and rear speaker units (fil-
ters) separately. When speaker units (filters)
are muted, no sound is outputted from those
speakers.
! Even if the speaker unit (filter) is muted,
you can adjust the muted speaker units (fil-
ters). However, mute is automatically can-
celed when the level is adjusted.
1 Use M.C. to select F.HPF 1 (or R.HPF 1).
Refer to Introduction of audio adjustments on
page 20.
2 Press M.C. to mute the selected speaker
unit (filter).
MUTE is displayed.
# To cancel the muting, press M.C. again.
Setting the high pass filter for front
speakers
1 Use M.C. to select F.HPF 1.
Refer to Introduction of audio adjustments on
page 20.
2 Turn LEVER to select slope.
–12— –6—Pass (dB/oct.)
# If you set the slope Pass (0 dB/oct.), the audio
signal bypasses the filter, so the filter does not
have an effect.
3 Press /DISP to display the upper tier.
4 Use M.C. to select F.HPF 2.
Refer to Introduction of audio adjustments on
page 20.
En
26
Section
02
Operating this unit

   Find Your Products By Category