Pioneer Car Stereo System Pioneer Car Stereo System User Manual

0

Out of 0 Ratings

Owner's of the Pioneer Car Stereo System Pioneer Car Stereo System gave it a score of 0 out of 5. Here's how the scores stacked up:

  • Reliability

    0 out of 5

  • Durability

    0 out of 5

  • Maintenance

    0 out of 5

  • Performance

    0 out of 5

  • Ease of Use

    0 out of 5
of 52
 
Adjusting equalizer curves
The factory supplied equalizer curves, with the
exception of Flat, can be adjusted to a fine de-
gree (nuance control).
1 Use M.C. to select EQ 1.
Refer to Introduction of audio adjustments on
page 20.
2 Turn M.C. to select an equalizer curve.
3 Turn LEVER to adjust the equalizer
curve.
+6 to –6 is displayed as the equalizer curve is
increased or decreased.
# The actual range of the adjustments are differ-
ent depending on which equalizer curve is se-
lected.
# The equalizer curve with all frequencies set to
0 cannot be adjusted.
Adjusting the 16-band graphic
equalizer
You can adjust the level of each band for the
Custom1 and Custom2 equalizer curves.
! A separate Custom1 curve can be created
for each source. If you make adjustments
when a curve other than Custom2 is se-
lected, the equalizer curve settings will be
recorded in Custom1.
! A Custom2 curve that is common for all
sources can be created. If you make adjust-
ments when the Custom2 curve is se-
lected, the Custom2 curve will be updated.
1 Recall the equalizer curve you want to
adjust.
Refer to Recalling equalizer curves on the pre-
vious page.
2 Use M.C. to select EQ 2.
Refer to Introduction of audio adjustments on
page 20.
3 Turn M.C. to select the equalizer band
to adjust.
20—31.5—50—80—125—200—315—500—
800—1.25k—2k—3.15k—5k—8k—12.5k—
20k (Hz)
4 Turn LEVER to adjust the level of the
equalizer band.
+6 to –6 is displayed as the level is increased
or decreased.
# You can then select another band and adjust
the level.
5 Press BAND/ to cancel the 16-band
graphic equalizer adjustment.
Adjusting loudness
Loudness compensates for deficiencies in the
low-frequency and high-frequency ranges at
low volume.
1 Use M.C. to select LOUD in the audio
function menu.
Refer to Introduction of audio adjustments on
page 20.
2 Press M.C. to turn loudness on.
# To turn loudness off, press M.C. again.
Adjusting source levels
With SLA (source level adjustment), the vo-
lume levels of each source can be adjusted to
prevent significant differences between
sources.
! Settings are based on the FM volume level,
which remains unchanged.
1 Compare the FM volume level with the
level of the source you wish to adjust.
2 Use M.C. to select SLA in the audio
function menu.
Refer to Introduction of audio adjustments on
page 20.
En
28
Section
02
Operating this unit

   Find Your Products By Category